MCP2515 CAN Module TJA1050 Receiver SPI 51

MCP2515 CAN Module TJA1050 Receiver SPI 51

385.00 (326.27 + GST)

In stock

385.00 (326.27 + GST)

This is MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino designed specifically to control any CAN Bus device, you will find easy to control any CAN Bus device by SPI interface with your MCU, such as Arduino UNO and Compatible with Arduino based micro-controllers.

Availability: In stock SKU: 2909 Category:
Buy this product to earn 3 Maker Points worth ₹3.
View cart

Description

This is MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino designed specifically to control any CAN Bus device, you will find easy to control any CAN Bus device by SPI interface with your MCU, such as Arduino UNO and Compatible with Arduino based micro-controllers.

A Controlled Area Network defined as a simple bus standard. It allows a Microcontroller and its peripheral devices to communicate without the need of a host device or a computer.  MCP2515 CAN Bus Controller module supports CAN Protocol version 2.0B standard and can be used for communication at 1Mbps. So this particular module is based on MCP2515 CAN Controller IC and TJA1050 CAN Transceiver IC. The MCP2515 IC is a standalone CAN Controller and has integrated SPI Interface for communication with microcontrollers.

In this module, MCP2515 IC function as the main controller that internally consists of three main subcomponents: The CAN Module, the Control Logic and the SPI Block. CAN Module is capable of transmitting and receiving messages on the CAN Bus. Whereas the Control Logic handles the setup and operation of the MCP2515 by interfacing all the blocks. And the SPI Block is responsible for the SPI Communication interface. Thus TJA1050 IC, function as an interface between the MCP2515 CAN Controller IC and the Physical CAN Bus.  This IC function for the data transmission from the controller and relaying it on to the bus.

Pin Details:
  1. VCC – 5V DC
  2. GND – Ground pin
  3. CS SPI – SLAVE select pin (Active Pin)
  4. SO – SPI Master Output Slave Input pin
  5. SCLK – SPI clock pin
  6. INT – MCP2515 interrupt pin
Interface
  1. J1 120R resistor terminal selection
  2. J2 CANH, CANL KF301-2P block output
  3. J3 CANH, CANL pin output

Features :

  1. Support CAN V2.0B technical standard, communication rate 1Mb / S.
  2. 0 to 8 bytes long data field.
  3. Use High-speed CAN transceiver TJA1050
  4. SPI control for expanding Multi CAN bus interface
  5. Use serial port could view the communication data
  6. With the independent key, LED indicator, Power indicator
  7. With power pin
  8. Standard frames, extended frames, and remote frames.
  9. Impedance matching, guaranteed drive capability, long-distance data transmission, prevent signal radiation
  10. Positioning screw hole center spacing 23 mm x 38 mm
  11. The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.

APPLICATIONS:

  • Electronic Gear Shift System
  • Automobile sensor communication
  • Main Interface in Automation (like industrial)
  • Medical Equipment
  • Robotics
  • Auto Start/Stop of Car Engine

Package Includes:

1 x MCP2515 CAN Module TJA1050 Receiver SPI 51

Reviews

There are no reviews yet.


Only logged in customers who have purchased this product may leave a review.