Uno R3 Board without Cable compatible with Arduino

Uno R3 Board without Cable compatible with Arduino

Uno R3 Board without Cable compatible with Arduino

650.00 (550.85 + GST)

Out of stock

650.00 (550.85 + GST)

  1. Micro-controller : ATmega328.
  2. Operating Voltage : 5V.
  3. Input Voltage (recommended) : 7-12V.
  4. Digital I/O Pins : 14 (of which 6 provide PWM output).
  5. Analog Input Pins : 6.
Availability: Out of stock SKU: 2466 Categories: , , Tags: , ,

Description

Uno is the most commonly used development board due to its flexibility. It has Female GPIO Ports and it is easy use without even need of a breadboard. You can simply use a single core wire also instead of a jumper wire. Other than that, it has onboard voltage regulators, Serial Interface IC that is very useful to upload programs frequently without wiring up the programmers. An Uno and a printer cable is enough to do most of prototyping purpose. So if you are a beginner, it is always recommended to use Arduino Uno than any other variant boards.

The Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your UNO without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

Pinout of Arduino Uno:

Uno R3 Board without Cable compatible with Arduino Uno R3 Board without Cable compatible with Arduino Uno R3 Board without Cable compatible with Arduino

Package Contains:

1 x Uno R3 Board without Cable compatible with Arduino

Note: Cable not included

MicrocontrollerATmega328P
Operating Voltage5V
Input Voltage (recommended)7-12V
Input Voltage (limit)6-20V
Digital I/O Pins14 (of which 6 provide PWM output)
PWM Digital I/O Pins6
Analog Input Pins6
DC Current per I/O Pin20 mA
DC Current for 3.3V Pin50 mA
Flash Memory32 KB (ATmega328P)
of which 0.5 KB used by bootloader
SRAM2 KB (ATmega328P)
EEPROM1 KB (ATmega328P)
Clock Speed16 MHz
Length68.6 mm
Width53.4 mm
Weight25 g

Reviews

There are no reviews yet.


Only logged in customers who have purchased this product may leave a review.